Craig and I decided to try our hands at making some Roman shades out of vinyl mini blinds for our kitchen/family room. I had read a couple of tutorials that made the project seem to be pretty simple (here and here). Unfortunately, the project turned out to be anything but simple for us thanks to a few different problems.
- The pattern on the fabric we chose is not perfectly straight (which we didn’t realize until we had completed one shade and realized it was completely crooked when we went to mount it to the wall).
- The widths of the windows plus the trim are odd sizes (so we couldn’t find vinyl mini blinds in the correct size).
- Our windows are installed flush with the drywall, which means that there are no window frames to mount the shades inside of.
So here’s what we did.
After one terribly crooked attempt, I decided to leave the fabric measuring, squaring, and cutting up to my engineer husband. He was so frustrated after our first attempt ended up crooked that he was determined to fix it and figure out how to make it work for the rest of them. So I just stepped back and left him to do his thing.
While Craig was engineering the heck out of the fabric I was busy in the other room disassembling the vinyl mini blinds.
After laying the blinds out on the floor I cut and removed the lateral strings that turn the slats. I was extra careful not to cut the thick lift cord that goes through the middle of each slat.
Then I removed the bottom bar and slid off the majority of the vinyl slats. I left 4 slats for the shade to be used over the sink and 5 slats for all of the other shades.
Once all of the fabric was measured, cut and hemmed we laid the vinyl blinds out on the fabric and marked where we needed to glue each slat. We decided to glue a slat every 10 inches. (Notice how the bar doesn’t go all the way to the edge of our fabric? That’s thanks to problem #2 listed above. I’ll talk about how we addressed that in a minute.)
After making all of our marks we began gluing the top and bottom bars and slats in place using fabric glue. We placed the glue on the convex side of the vinyl slats
Once all of the slats were glued in place we cut several of the leftover slats into 6 inch pieces. We then glued these pieces to the ends of the existing slats and bars which basically extended their widths that they ran all the way to the edge of the fabric.
Then after letting the glue set for a while Craig mounted the shades to the wall 6 inches higher than the window trim (to create the illusion of taller windows).
All in all, I think the finished products turned out great! What do you think?